Engine OBD Code

Triumph GT6 C1402 OBD Error

Mass Air Flow (MAF) Sensor Intermittent The MAF sensor circuit is monitored by the PCM for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM).

If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory diagnostic trouble code (DTC) is stored.

C1402 Code Symptoms

Check Triumph GT6 C1402 trouble code with comparing symptoms

If your C1402 Triumph GT6 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C1402 and engine control unit are in charge of monitoring a bunch of different C1402 OBD/2 Triumph GT6, and if they get a reading that's a little out of whack, up pops the check engine light.

C1402 DTC For Triumph GT6

OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

Fixing Ways For C1402 Code:

C1402 OBD2 Code Removal Process

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C1401 Previous Engine OBD Code For Triumph GT6 Next Engine OBD Code For Triumph GT6 C1403

About Us - Contact - Privacy Policy

Copyright 2019 © EngineOBDCode.com - Engine OBD and OBD2 Code Check-Up Tool